CCNA (200-120) 문제풀이 NO. 134
깜장뿔테오후 8:06
QUESTION 134 On which options are standard access lists based? A. destination address and wildcard mask B. destination address a...
CCNA (200-120) 문제풀이 NO. 133
깜장뿔테오후 8:06
QUESTION 133 What are two benefits of using NAT? (Choose two) A. NAT protects network security because private networks are not ad...
CCNA (200-120) 문제풀이 NO. 132
깜장뿔테오후 6:54
QUESTION 132 Which statement describes the process of dynamically assigning IP addresses by the DHCP server? A. Addresses are allo...
CCNA (200-120) 문제풀이 NO. 131
깜장뿔테오후 6:53
QUESTION 131 Refer to the exhibit. What statement is true of the configuration for this network? Based on the information sh...
CCNA (200-120) 문제풀이 NO. 130
깜장뿔테오후 6:22
QUESTION 130 Which type of EIGRP route entry describes a feasible successor? A. a primary router, stored in the topology table. ...
CCNA (200-120) 문제풀이 NO. 129
깜장뿔테오후 6:12
QUESTION 129 Which command shows your active Telnet connections? A. show cdp neighbors B. show session C. show users D. show...
CCNA (200-120) 문제풀이 NO. 128
깜장뿔테오후 10:37
QUESTION 128 What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router? ...
CCNA (200-120) 문제풀이 NO. 127
깜장뿔테오후 4:27
QUESTION 127 A router receives information about network 192.168.10.0/24 from multiple sources. What will the router consider the mo...
CCNA (200-120) 문제풀이 NO. 126
깜장뿔테오후 4:27
QUESTION 126 Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0?...
CCNA (200-120) 문제풀이 NO. 125
깜장뿔테오후 10:05
QUESTION 125 Which three elements must be used when you configure a router interface for VLAN trunking? (Choose three.) A. one phy...
CCNA (200-120) 문제풀이 NO. 124
깜장뿔테오후 9:45
QUESTION 124 Refer to the exhibit. What can be determined about the router from the console output? A. No configuration file...
CCNA (200-120) 문제풀이 NO. 123
깜장뿔테오후 9:01
QUESTION 123 Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? (Choose...
CCNA (200-120) 문제풀이 NO. 122
깜장뿔테오후 9:01
QUESTION 122 Which two statements describe the process identifier that is used in the command to configure OSPF on a router? (Choose t...
CCNA (200-120) 문제풀이 NO. 121
깜장뿔테오후 9:00
QUESTION 121 Refer to the exhibit. What commands must be configured on the 2950 switch and the router to allow communication between...
CCNA (200-120) 문제풀이 NO. 120
깜장뿔테오후 4:19
QUESTION 120 Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID wil...
CCNA (200-120) 문제풀이 NO. 119
깜장뿔테오후 4:19
QUESTION 119 Which two locations can be configured as a source for the IOS image in the boot system command? (Choose two.) A. RAM ...
CCNA (200-120) 문제풀이 NO. 118
깜장뿔테오후 4:17
QUESTION 118 Refer to the exhibit. Assuming that the entire network topology is shown, what is the operational status of inter...
CCNA (200-120) 문제풀이 NO. 117
깜장뿔테오후 4:16
QUESTION 117 Refer to the exhibit. Which address and mask combination represents a summary of the routes learned by EIGRP? A...
CCNA (200-120) 문제풀이 NO. 116
깜장뿔테오전 1:33
QUESTION 116 Refer to the exhibit. According to the routing table, where will the router send a packet destined for 10.1.5.65? ...
CCNA (200-120) 문제풀이 NO. 115
깜장뿔테오전 12:19
QUESTION 115 Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?...
피드 구독하기:
글
(
Atom
)
